![]() ![]() This boundary temp turns on the relay controlling the fan. I set the PID controller to 250 F (SV value). Three hickory wood chunks were placed from side to side on top of the charcoal. I then added ~10 white hot coals on the side furthest from the fan. I filled the smoker bottom with unlit charcoal. Today I cooked a 3 lb boston butt (pork, no bone). Tape off any exposed wire and wire screw cap connectors. First cut out all the holes in the project box and wire everything up. If you don't feel comfortable soldering just leave it out. ![]() You will need solder the circuit breaker from the ext. 225 F) that when the TC reads <225 the controller supplies power to the outlet (fan), thus increasing the smoker temperature. The device allows the user to set a lower temperature bound (i.e. ![]() PID controller The temp control type depicted in the wiring diagram does not utilize the PID portion of the controller. Place fan in the 3/4" conduit housing and seal with silicone. Place a strip of styrofoam on the bottom of the 3/4" conduit housing so the fan is not flush with the bottom of the housing. Then drill a hole for the 3/4 inch thread pipe (held on the inside of the duct end cap with a nut). This bolt will go through an air vent on the bottom of the smoker to hold the fan in place. Smoker fan attachment Using a metal bit drill a hole in the duct end cap offset from center for the carriage bolt. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |